2GMitsubishi
RCTalk Basher
My Volcano S30 will not start.. I have new fuel, new fuel filter, I cleaned the lines out just to be sure..
My carb settings are LSN 3 turns out and HSN 3 1/2 turns out.
New hot glow plug that tested good and I've got a full charge on my igniter.
Wtf could be the issue?
I've adjusted the LSN a quarter turn at a time from fully closed to four turns open and no where in between did I get a start.
It is a rotary carb
My idle is set at 1mm open.
The engine has a Mild port and polish..
My carb settings are LSN 3 turns out and HSN 3 1/2 turns out.
New hot glow plug that tested good and I've got a full charge on my igniter.
Wtf could be the issue?
I've adjusted the LSN a quarter turn at a time from fully closed to four turns open and no where in between did I get a start.
It is a rotary carb
My idle is set at 1mm open.
The engine has a Mild port and polish..