jayb6550
RCTalk Rookie
- Messages
- 23
- Reaction score
- 14
I have just gotten into the nitro rc hobby and was needing some help on this issue. Every time i start up the engine, it stalls shortly after starting. I constantly have to prime it and sometimes go as far as taking off the filter and putting fuel directly into the carburetor. the longest i’ve had it run was around 10 seconds and it ran hot the whole time. I thought tuning was the issue so i set the carb to factory settings and tried to tune from there and it helped a little but still did the same thing. my guess is there could be an air leak somewhere that i’m not seeing or it’s not pulling enough fuel. not sure if this will help but the engine is a dynamite mach .15r.